Revolabs Telephone cme series Bedienungsanleitung PDF herunterladen

Technical Note

1 | Page

FLX – VoIP Registering with Cisco UC500/CME Series

Date: March 13

, 2012

This technical note gives a detailed description on how to register a Revolabs FLX conference phone with

a Cisco UC 500/CME series. On the UC 500/CME series a SIP extension and user has to be created using

the Command Line Interface (CLI). Once that user is created, the FLX can be set up to register with the

UC500/CME series PBX.

To perform the tasks described in this document, the user needs to have administrative rights on the

Cisco UC500/CME. While the steps in this document are not difficult, we recommend that a trained

Cisco administrator should perform them.

The instructions provided here were collected using a Cisco UC560. Other versions of the Cisco

UC500/CME series may differ, though the general procedures are the same.

Configuring Cisco UC500 series PBX for FLX Registration

The configuration of SIP devices on the UC500/CME series is straightforward. The SIP CME feature in IOS

is used to register the FLX as a generic SIP endpoint.

The following IOS CLI commands are needed on the UC500/CME device. Please note that in your setup

the dn numbers and the pool might be different based on other SIP devices you have installed.

1 2 3 4 5

Technical Note 1 | Page FLX – VoIP Registering with Cisco UC500/CME Series Date: March 13th, 2012 This technical note gives a detailed d

Seite 2

FLX & Cisco UC500/CME Technical Note 2 | Page voice register global mode cme source-address 10.1.1.1 port 5060 ----- IP used for SIP Registrar/

Seite 3

FLX & Cisco UC500/CME Technical Note 3 | Page Registering the FLX with the Cisco UC500/CME You can use either the FLX handset or the FLX web U

Seite 4

FLX & Cisco UC500/CME Technical Note 4 | Page Username – enter the same User ID as above Password – the End User’s password, in our example ext

Seite 5

FLX & Cisco UC500/CME Technical Note 5 | Page 7. For the DTMF Signaling method select “SIP INFO”. 8. Press “Save”. 9. On the left side se

Keine Kommentare

Revolabs Telephone cme series Bedienungsanleitung